Entry Gear

(Sold)SCHECTER/EX-JV310 FRT S-GRN

owner: Shin

2020.3.11: I feel like it was a rather good one when I bid on it in junk condition.
I often see similar ones but I am not sure of the model name or other details.
I think it is a mass-produced model made in Japan, but I don't think it is a cheap model either, because it has a bird's eye maple neck, although it is modest.
The base plate of the bridge is old and the studs are wood screws, so I think it was made in the early 90's. Two of the pots are stuck.
Two pots were sticking, and I found two new pots in the case that the previous owner was going to replace them.
The rear PU was a JB, but it was not trem pitch, so I replaced it with an old TB-5 that I had left over.
The tremolo springs were set up with 2 power springs and the insert blocks were all replaced with titanium ones since 4 of them were broken.
All PUs are coil-tapped when the low-cut tone knob is pulled, and the Vol has a high-pass capacitor and resistor.
There was no evidence of re-soldering, so I assume it is a full Ori circuit except for the rear PU.
There was a metal knob on it, but I changed it to a strat type for my preference.
2021.12.9: The neck shim was too thick, so I replaced it with an ESP 0.5mm shim and reassembled it.
The strings have been loose since I got it, so the neck is still warped and the rod is still loose.
It is set up without any sound blockage.
2022.3: I sold it because I never used it.
I later found out the model number is the one in the title.