Entry Gear

(Sold) BURNY/RLC-70S

owner: Shin

2018.2.13: I dropped this off at auction as junk.
It was missing the jack, selector knob, lock nut cap, tension bar, pick guard, control panel, rod cover, and arm, and one jack plate, selector, insert block, and one plastic ring on the peg was damaged.
The frets are also groove worn and floating, and the body is partially tanned and gradient colored (lol).
I've been wondering how Floyd would look on a Les Paul for a while, and I finally got it as junk because it was often over my budget when it was listed on the market.
I got all the missing/damaged parts except the rod cover and assembled it.
I bought a generic pickguard, but the rear PU was slightly closer to the front to increase the distance from the bridge stud, so I had to cut the pickguard by myself to make it fit.
The rod cover also has a tension bar, so I had to give up on the rod cover because the threaded holes did not fit for a generic one...
The power seems to be good, but I could not hear any sound from the front sustainer driver.
2018.2.24: At the workshop, I wondered if it could be due to some parts of the board failing? I tried my luck, but the problem was fixed when I had it replaced!
The replacement part is the last one in stock and will not be available in the future...
2018.4: The fret replacement is still expensive and there are some missing parts that cannot be replaced, so I sold it, although it was a bit of a waste of money.