Entry Gear

(Sold) Bacchus - HJG-24HH FRT/M CAR-MH

owner: Shin

2017.9.23: This is an Ikebe Instruments original design that was released around last year, I believe.
The 1st lot sold out immediately, and I was planning to buy it again around spring this year, but the Ikebe near me didn't have this red one that I wanted, so I bought it while I went to Tokyo to play lol.
The original is a medium scale neck and reverse head.
I looked at two stores and chose the cleaner one, but when I got home and adjusted it, the flange fingerboard part of the high position was horribly warped backwards and the 24th fret was sunk almost 0.5mm more than the 23rd fret...
2017.11.2: The fretboard was repaired by the manufacturer and returned to my possession after about a month, but the fret rubbing in the high position was not done properly and there was a dead position on the first string chalking. There was a dead position...
Moreover, when the frets were deburred, the sides of the fretboard were rounded off too much, so that even the edge of the fingerboard on the first string side was rounded off, making it easy for the strings to fall off....
Also, it turned out that the conductive paint inside the cavity was not conductive and was not noise suppressed when I used a tester.
2018.3: The neck was remanufactured and returned, but the quality of the frets were not like those on a new neck and were partially flat fret rubbed together, so I returned it.
2018.4: Finally completed after having the frets reprocessed by the manufacturer.
I have not been able to play it for 6 months since I purchased it and will now use it.
2019.3: The bridge floated as much as I played arming even after replacing the spring, the neck warped even with thin strings, and the wood had thinned over the year and burrs began to show from the edge of the frets. I couldn't take it any longer and sold it...